Removing The Cover - NEC DS2000 Hardware Manual

8' X 4' Plywood backboard
Dedicated
AC Outlet
Surge
Protector

Removing the Cover

Before wall-mounting, remove the cover on the Main Equipment Cabinet.
To remove the cover (Figure 1-3):
1. Unscrew the two captive screws on the front of the cabinet cover.
2. Lift up slightly on the front of the cover — then gently slide the cover back to remove it.
DS2000 Hardware Manual
Trunk
Blocks
Station
Blocks
To telco To earth
ground ground
Figure 1-2: 8 Slot Cabinet Installation Layout
Figure 1-3: Removing the Cover
Installing the Cabinet
Note: The system will respond to telco ring signal in the
range of 40-130 VAC @ 20 Hz.
Station
Blocks
4 Slot Cabinet Shown
Section 1: Installing the Cabinet N 1-9
1