Siemens 3964R User Manual page 9

5
Select the number of Data Bits that matches the configuration of the Siemens device.
Select the number of Stop Bits that matches the configuration of the Siemens device. If
the Baud Rate is greater than 300, the Stop Bits should be set to 1.
Select the Parity setting that matches the configuration of the Siemens device.
All devices on a single communication port must be configured with the same Baud
Rate, Data Bits, Stop Bits, and Parity.
Click Defaults to reset the settings to their default values without saving changes.
Click Save to save settings for the selected COM Port. The dialog box will remain
displayed giving you the option to configure additional COM Ports.
Click Done to close the dialog box. If the settings have not been saved, the following
dialog box will appear:
Click Yes to save settings for the COM Port.
Click No to prevent saving the settings.
Click Cancel to return to the Communication Port Settings dialog box without saving
the settings.
Note For most of these settings only one setting is allowed. All other possibilities are
disabled.