DTC P0460 Fuel Level Sensor Circuit High Input
WIRING DIAGRAM/CIRCUIT DESCRIPTION
1. Fuel level sensor
2. Fuel meter in combination meter
3. ECM (PCM)
DTC DETECTING CONDITION AND TROUBLE AREA
DTC DETECTING CONDITION
Fuel level sensor output voltage higher than specified
value is detected for specified time.
(2 driving cycle detection logic)
DTC CONFIRMATION PROCEDURE
NOTE:
Check to make sure that following condition is satisfied when using this "DTC CONFIRMATION PRO-
CEDURE".
• Intake air temp. : – 8°C (18°F) or higher
• Engine coolant temp. : – 8 – 110°C (18 – 230°F)
• Altitude (barometric pressure) : 2400 m, 8000 ft or less (560 mmHg (75 kPa) or more)
1) Connect scan tool to DLC with ignition switch OFF.
2) Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and run
engine for 1 min.
3) Check pending DTC by using scan tool.
ENGINE GENERAL INFORMATION AND DIAGNOSIS (H27 ENGINE) 6-1-103
• Fuel level gauge or its circuit
• Fuel level sensor or its circuit
• ECM (PCM)
TROUBLE AREA