Rear Blower Motor Resistor - Suzuki GRAND VITARA XL-7 Owner's Manual

1
3
Mo
L
MH ML
1
INSPECTION
• Check rear A/C main switch for each terminal-to-terminal
continuity.
If check results are not specified, replace rear A/C main
switch.
POSITION
ON
OFF
INSTALLATION
Reverse removal procedure for installation.

Rear Blower Motor Resistor

REMOVAL
1) Remove rear A/C unit referring to "REAR A/C UNIT" in this
section.
2) Disconnect rear blower motor resistor connector (1).
2
3) Remove rear blower motor resistor (2) from rear A/C unit (3).
INSPECTION
Measure each terminal-to-terminal resistance.
If measured resistance is incorrect, replace rear blower motor
resistor (1).
Rear blower motor resister resistance
Mo-L : Approx. 2.4 Ω Ω Ω Ω
Mo-ML : Approx. 1.2 Ω Ω Ω Ω
Mo-MH : Approx. 0.6 Ω Ω Ω Ω
INSTALLATION
Reverse removal procedure to install rear blower motor resistor.
TERMINAL
a b
AIR CONDITIONING (OPTIONAL) 1B-35
c d e