Mitsubishi Electric 738 Series Owner's Manual page 72

72
6. NetCommand Control of an A/V Receiver (838 Series)
Setting Up A/V Receiver Control, continued
NetCommand Control of a Device Con-
nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
You must have already completed the procedure under
"Setup to Control Automatic Audio and Video Switch-
ing via HDMI" on the previous page. That procedure
placed an icon in the Input Selection menu for the
device (input) connected to the A/V receiver.
Any Connection
Source
Device
Downloaded From TV-Manual.com Manuals
For assistance call 1(800) 332-2119
Type
A/V
Receiver
1.
Set up NetCommand control of A/V receiver audio/
video switching via HDMI as described on the pre-
vious page.
2.
Press
normal TV viewing.
3.
Press
4.
Highlight the icon for the device connected to the
A/V receiver input you wish to control.
5.
Press
and the A/V receiver to the input.
6.
Open the
HDMI
7.
Perform NetCommand "learning" for the con-
Cable
nected device by following the steps in
NetCommand Setup," page
TV
EXIT to close any open menus and return to
INPUT.
ENTER to switch the TV to the A/V receiver
Inputs > Learn menu.
64.
"Initial