Table of Contents
Advertisement
64
5. NetCommand IR Control (838 Series)
NetCommand Setup
Initial NetCommand Setup
To perform this procedure, you need:
•
The remote controls for both the TV and the
device you want to control.
•
An IR emitter cable available from Mitsubishi
Note: To set up an A/V receiver, see
Receiver Control," page
1.
Connect and position the IR emitters for the
devices you wish to control. See
the previous
page.
2.
Set the
TV's remote control to TV mode and power
on the TV.
NetCommand and Device-Specific Keys
Device-specific keys are those which have no
equivalent on the TV's remote control. Use any of
these methods to set up NetCommand control for
these keys.
•
TOO
LS Menu. In some cases, the TV will, by
default, assign a key to the TOOLS menu. See
the table below.
Examples of Default NetCommand
Assignments in the TOOLS Menu
Cable Box, Sat-
ellite Receiver
DVD, DVR,
Blu-ray
VCR
A/V Receiver
NetCommand's default setup assigns some
device-specific keys to the TOOLS menu when
"learned." These key functions are accessible only
with the TOOLS key.
•
F
Keys. There are four F keys, F1 through F4,
which you can assign to any function on the
device's remote control. For a cable box,
"learn" the F keys as the A, B, C, D keys.
•
Arbitrary Key Assignment. You can assign a
device key arbitrarily to any "unlearned" key
on the TV's remote control. Make a note of the
key name and function for later reference.
Downloaded From TV-Manual.com Manuals
For assistance call 1(800) 332-2119
.
"Setting Up A/V
69.
"IR Emitters"
on
MENU
3
ON DEMAND
9
SETUP
3
TOP MENU
6
ANGLE
9
MENU
3
INPUT
6
MENU
3
SURROUND
6
3.
Switch the TV to the desired input to control. Press
INPUT, highlight the input icon, and press ENTER.
4.
Open the NetCommand
5.
The first function highlighted in the
is always Power On. Aim the TV's remote control
at the TV and press ENTER to begin learning for that
function.
6.
Power On text starts flashing, aim the
When the
device's remote control at the TV and hold the POWER
key until a check mark appears next to Power On.
•
If the text stops flashing before the check mark
appears, repeat the previous step.
•
To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
•
To verify the device's response to the IR code,
press ENTER to send out the code.
Inputs > Learn screen. Key names marked with a check
have been "learned."
Some device-specific keys, such as MENU, are available
only from the TOOLS menu after "learning."
7.
Use navigation
keys on the TV's remote control to
highlight other keys on the list. Repeat steps 5 and
6 for each additional function you wish to control
through NetCommand.
8.
If the device has a separate POWER OFF key, use
navigation keys on the TV's remote to highlight
Power Off. Repeat the earlier steps to "learn" the
POWER OFF key.
If the device has no POWER OFF key, skip this step.
9.
Press
EXIT to finish NetCommand "learning" for the
current device.
Inputs > Learn menu.
Learn screen
Advertisement
Table of Contents
Troubleshooting
