Figure 122: Screws Of The Back Panel; Figure 123: Internal Jumper - GE RPV311 Technical Manual

RPV311
RPV311-TM-EN-7
In order to configure the analog input to measure voltage signals of DC transducers,
remove all connectors and cables which are connected to the module and remove
the back panel of the RA331, RA332 or RA333, removing the 12 screws of the panel
and the screw of the protective grounding, as shown in
The fixing screws are not included in the product order.

Figure 122: Screws of the Back Panel

Remove the board corresponding to the channel to be configured. For each channel
to be configured to DC transducers of ± 10 V, connect the jumper between positions
1 and 2 as shown in Figure 123.

Figure 123: Internal Jumper

Chapter 15 – Installation
Figure 122.
234