Installation; Installation Site - Sanyo MCO-5M Instruction Manual

Multi-gas incubator
Hide thumbs Also See for MCO-5M:
Table of Contents

Advertisement

INSTALLATION

Installation site

To operate this unit properly and to obtain maximum performance, install the unit in a location with the
following conditions:
Note: The ambient temperature must be at least 5
1. A location not subjected to direct sunlight or direct air flow from an air conditioner
2. A location with clean air and adequate ventilation (Small and sealed room is not recommended.)
WARNING
As with any equipment that uses CO
the equipment. It is important that you assess the work site to ensure there is suitable and sufficient
ventilation. If restricted ventilation is suspected, then other methods of ensuring a safe environment
must be considered. These may include atmosphere monitoring and warning devices.
O
gas increases the susceptibility of substances to burn. Take care of the handling of flame in a room
2
where the incubator is installed.
3. A location away from heat generating sources
4. A location with a sturdy and level floor
WARNING
Install the unit on a sturdy floor. If the floor is not strong enough or the installation site is not
adequate, this may result in injury from the unit falling or tipping over.
Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.
Improper installation may result in water spillage or injury from the unit tipping over.
5. A location without flammable or corrosive gas
WARNING
Never install the unit in a flammable or volatile location. This may cause explosion or fire.
Never install the unit where acid or corrosive gases are present as current leakage or electric shock
may result due to corrosion.
6. A location not prone to high humidity ( more than 80% )
WARNING
Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to
rain water.
Never install the unit in a humid place or a place where it is likely to be splashed by water.
Deterioration of the insulation may result which could cause current leakage or electric shock.
o
C lower than the set temperature.
/O
/N
gas, there is a likelihood of oxygen depletion in the vicinity of
2
2
2
72
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents