Turning On The Hp 16500A/16501A; Installing The Operating System Disk - HP 16500a Setting Up

2
Turning On the HP 16500A/16501A
Installing the
Operating
System Disk
J
Note ' "
HP 16500A/16501A
Setting Up the System
Once you have prepared the HP 16500N1650lA for operation, as
discussed in Chapter 1, you are ready to turn on the instrument. In this
chapter you
will
learn how to install the operating system disk, connect
any optional accessories you have, and turn on the instrument. This
chapter also describes the steps the HP 16500N1650lA completes
during power-up. Finally, you
will
learn how to adjust the brightness,
background, and tilt stand and how to use each of the four available
user interfaces.
The HP 16500N1650lA operating system disk contains a set of
programs that controls the operation of the instrument. The operating
systems are on 3.5 inch disks that you can install into either the front or
rear disk drive. Typically, Disk 1 is installed in the rear disk drive. and
Disk 2 (if supplied) is installed in the front disk drive. To install the
operating system disk follow these steps:
1. Hold the disk labeled "Factory Configured Software for HP
16500A Logic Analysis System (Disk 1)" so that the label is on
top and the metal auto-shutter is away from you.
2. Push the disk gently, but firmly, into the rear disk drive until it
clicks into place.
If the Factory Configured Software for HP 16500A Logic Analysis
System is on two disks, install one disk in each disk drive.
Turning On the HP 16500A/16501A
2-1