Adjusting The Image Reading Start Position (Adj - Canon CLC5100 Series Manual

Chapter 2
Using the Two Sided Copies as the source of Paper
Loosen the screw [1], and adjust the position of the
paper guide plate so that the standard value is attained.
[1]
F-2-15
b. Adjusting the Image Margin
F-2-16
1) Start service mode, and select 'ADJUST > FEED
ADJ'.
2) While the 'FEED ADJ' screen is on, press the Start
key.
3) If the image margin is not as indicated, adjust the
image writing start position in the main scanning
direction using 'UPADJ', 'LOW ADJ', 'MULT
ADJ', 'DECK ADJ', and 'REFE ADJ' and using
'VSYC ADJ' in the sub scanning direction.
Then, adjust the non image width using 'MARGIN L,
R, T, B'.
(For details, see. "SERVICE MODE.")
2-10
2.2.4 Adjusting the Image
Reading Start Position
(ADJ XY)
CLC5100 / CLC4000
<M> ADJ-XY
<S>
DISP COUNTER ADJ-X
xxxx
ADJUST ADJ-Y
xxxx
FUNC ADJ-S
xxxx
OPTION ADJ-J
xxxx
TEST
F-2-17
1) Start service mode, and select 'ADJUST > ADJ
XY'.
2) While the 'ADJ XY' screen is on, press the Start
key.
The appropriate copying mode will be set
automatically, and a copy is made with a shift of
about 20 mm as shown in the Figure.
3) If a portion of the image is missing, decrease the
setting of 'ADJ X' and 'ADJ Y'.
4) If an area outside the image area is copied, increase
the setting of 'ADJ X' and 'ADJ Y'.
5) Press the Start key once again, and check the
output.
6) Press the Reset key.
F-2-18
0002-3604
<R> READY <P> READY <F>