Initializing The Ram On The Reader Controller Pcb; When Replacing The Image Position Correction Ccd Unit; When Replacing The Paper Thickness Sensor - Canon CLC5100 Series Manual

Chapter 2
ADJUST Settings on PASCAL screen
Settings on FEED ADJ
screen
Settings on ENV SET screen
Settings on HV TR C/M/Y/K
screen
Settings on HV SP screen
Settings on HV FS screen
Settings on HV EL screen
FUNC Settings on DC CON screen
Settings on P UP TMG
screen
Settings on P THICK screen
Settings on IMG REG screen
Settings on FUSER screen
OPTION Settings on P OPT screen
(except ON SET)
2.7.5 Initializing the RAM
on the Reader Controller
PCB
CLC5100 / CLC4000
1) Record the settings of user mode.
2) Execute 'FUNC>R CON>RAM CLR' in service
mode. (The power switch will automatically turn
off.)
3) Turn on the power switch.
4) Execute 'FUNC>CCD>AUTO ADJ' in service
mode. (about 8 min)
5) If a projector is installed, execute 'FUNC>PROJ
ADJ>PROJ CCD' in service mode.
6) Enter any new user mode settings and the settings
recorded in B of the service label. (If you have
changed any other service mode settings related to
the reader controller, enter such settings.)
2-28
T-2-6
0002-5905
2.7.6 When Replacing the
Image
Correction CCD Unit
CLC5100 / CLC4000
1) After replacing the image position correction CCD
unit, execute
screen)>REG APER' in service mode. Thereafter,
be sure to turn off and on the power switch to
correct the image position.
2.7.7 When Replacing the
Paper Thickness Sensor
CLC5100 / CLC4000
1) Check the settings (A through E) recorded on the
label attached to the paper thickness sensor you are
replacing, and record them under 'SNSR RNK' on
the service label. At this time, you need not perform
step 3) and the subsequent steps if the settings are
the same as the settings under 'FUNC>P
THICK>SNSR RNK' of service mode.
2) Replace the power thickness sensor.
3) Enter the settings you recorded on the service label
in step 1) under 'FUNC>PTHICK> SNSR RNK' in
service mode. (Each press on 'SNSR RNK' toggles
the settings A through E.)
4) Check to make sure that the values of 'P TH 1' and
'P TH 2' are identical to the values recorded on the
service label; if different, enter the correct values
using 'FUNCDC CON (5/5)>P TH 1/2' in service
mode.
5) End service mode.
Position
0002-0451
'FUNC>INSTALL
0002-0456
(2nd