Mitsubishi Electric AE-200A Service Handbook page 104

[VIII Maintenance]
[Work procedure 1: Update PC settings] (Procedure using a Web browser)
(1) Change the IP address of the PC.
Click [Start] → [Control Panel] → [Network Connections], right-click [Local Area Connection], and select [Properties] to display the
following dialog box.
* When updating an AE-200/AE-50/EW-50 that is already operating, check the IP address of the AE-200/AE-50/EW-50 and then
configure the setting.
If the IP address of the AE-200/AE-50/EW-50 is [192.168.1.1], enter the same values for the first three numbers and enter a different
number for the fourth number to set an IP address such as [192.168.1.2].
Note: If the update will be performed with a PC that is already connected to the on-premises LAN, the subnet mask may different
from the above.
If the subnet mask is [255.255.0.0], enter the same values for the first two numbers (192.168) of the IP address and set the
third and fourth numbers so that they differ.
* When the PC is connected to the on-premises LAN, obtain the permission of the network administrator before configuring the network
settings and performing the update.
* The factory default setting for the IP address of the AE-200/AE-50/EW-50 is [192.168.1.1].
Select [Internet Protocol Version4 (TCP/IPv4)] and click [Properties].
The dialog box on the left appears next. Select [Use the following
IP address] and then enter [192.168.1.*] for the IP address.
(For the * part, enter a number that is different from that of the IP
address of the AE-200/AE-50 to be updated.
100