Bosch DCN Next Generation Installation & User's Instructions page 60

DCN Next Generation | Installation and User Instructions | Central Devices
2 Connect the LTC5136 AutoDome Controller to the
AutoDome video camera.
3 Set the pre-positions of the AutoDome video camera
with the AutoDome controller.
4 Make sure that all pre-positions of the AutoDome
video camera are correct.
5 Disconnect the LTC5136 AutoDome Controller from
the AutoDome video camera.
6 Set the protocol and baudrate for serial port 1 and
serial port 2 of the central control unit (refer to
section 8.3.2 and table 8.20).
table 8.20: DCN-CCU to PC and AutoDome
Device Serial port
PC Port 1
AutoDome Port 2
7 Connect the serial ports of the central control unit to
the PC and the AutoDome video camera (refer to
figure 8.24 and figure 8.25).
9 pole D-type
(male)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
DCN-CCU
figure 8.24: DCN-CCU to PC
Bosch Security Systems | 2007-02 | 9922 141 70525
figure 8.25: DCN-CCU to AutoDome
Settings
Protocol:
Full
Baudrate:
115.2k
Protocol:
Camera control 8 Install the LBB4188 Camera Control software
module in the PC (refer to the DCN Next Generation
Baudrate:
Software Installation Instructions).
9.6k
9 Attach the pre-positions of the AutoDome video
camera to the seat numbers with the LBB4188
Camera Control software module (refer to the User
Manual of the LBB4188 Camera Control software
module).
9 pole D-type
8.9.5
(female)
8.9.5. 1
1 DCD
Refer to figure 8.26 for an overview of a system with a
2 RxD
3 TxD
PC and camera control through a video switcher.
4 DTR
5 SG
6 DSR
7 RTS
8 CTS
9 RI
PC
DCN-CCU
figure 8.26: Video switcher with a PC
8.9.5.2
These are the requirements for a system with camera
control through a video switcher with a PC:
9 pole D-type
(male)
DCD 1
RxD 2
TxD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
RI 9
DCN-CCU
Note
Refer to section 8.5.8 for maximum cable
lengths.
Video switcher with a PC
Overview
Video cameras
PC
Port 1
ALLEGIANT Video Systeem
Port 2
Allegiant
Requirements
en | 60
Terminal
1 SG
2 TxD
3 RxD
4 +BP
5 -BP
6 SHLD
7 +BP
8 -BP
AutoDome
Power
Code Out
Alarm
Status
Battery Low
Video display