Bosch DCN Next Generation Installation & User's Instructions page 64

DCN Next Generation | Installation and User Instructions | Central Devices
8. 1 0.2. 1 1 To select a parameter
1 Open the correct menu item (refer to section
8.10.2.10).
2 Turn the knob to move the cursor to the parameter
that is shown.
3 On the parameter, push the knob. The parameter
flashes.
4 Turn the knob to go to the applicable parameter.
5 When the display shows the applicable parameter,
push the knob to select the parameter. The display
shows a cursor.
8. 1 0.2. 1 2 To change the value of a parameter
1 Select the applicable parameter (refer to section
8.10.2.11).
2 Turn the knob to move the cursor to the value.
3 Push the knob. The value flashes.
4 Turn the knob to go to the value.
5 When the display shows the correct value, push the
knob to select the value. The display shows a cursor.
8. 1 0.2. 1 3 To close a menu item
1 Turn the cursor to the last character that identifies
the menu item.
2 Push the knob to close the menu item. The last
character and the menu item title flash.
8. 1 0.2. 1 4 To close a sub-menu
1 Turn the cursor to go to the last character but one
that identifies the menu item.
2 Push the knob to close the sub-menu. The last
character and the menu item title flash.
8. 1 0.2. 1 5 To close the main menu
1 From the main menu, turn the primary knob
clockwise to go to the < Back menu item.
2 From the < Back menu item, push the knob to go to
the Main menu item.
Bosch Security Systems | 2007-02 | 9922 141 70525
8. 1 0.2. 1 6 Example
For an example, do as follows to change the level of
audio input 2 of the central control unit:
Note
Make sure that when you do this example, you
start from the main screen.
1 Push the knob to open the main menu.
2 Turn the knob clockwise until 7 Setup ... is reached.
3 Push-and-hold the knob for 3 seconds to open the
sub-menu.
4 Turn the knob clockwise until 7H Level is reached.
5 Push the knob to go to the sub-menu.
en | 64