Fujitsu TeamPad 7100 Supported Equipment Manual page 47

Message Reason
Font Loading Error; Could not load the font.
Printer Not Ready\nPress R Can not print.
to Retry\nC to Cancel Print;
Mobile Unit Running in demo mode.
in\nDemonstration
Mode\nfor TwinClient;
Connected to Host; Successful connection to the target Host.
Telnet Mode not\nsupported This Mobile Unit must be used with a
on\nthis Mobile Unit; Connect Server.
Telnet Setup files\nnot Customer specific configuration files are
found. Reload\nfiles then missing.
switch;
Switched Client to\nTelnet Mobile Unit running in Telnet mode direct to
Direct Mode; the target Host.
Switched Client to\nServer Mobile Unit running through a Connect
Based Mode; server in Server mode usually at port 1800.
Port 23 is only\nallowed in Can not set the port to 23 in Server mode.
Telnet Mode; Port 23 is the standard Telnet port.
Not Enough Memory\nTo Mobile Unit does not have the capacity to
Run; run the program do to memory restrictions.
Press any key; Press a key to continue.
•
Supported Equipment Manual May, 2006
Solution
Ensure that the font is available to load.
Check cable, battery, communication settings
and paper in the printer.
Purchase a license from Connect.
Advisory message.
Order a Connect Server.
Load the configuration files into the Mobile
Unit from Twin Client Manager.
Advisory message.
Advisory message.
Advisory message.
Expand the Mobile Unit memory.
Advisory message.
Error Message Resolution Guide
Reference Tech Note
---
---
---
---
---
---
---
---
---
---
---
4-7