Haier HTD1268 Service Manual page 11

Installation
1. Place the threaded end of the water inlet hose on
the water inlet valve connector. threaded end of
2. Check that the connection is correct by
tightening the threaded end on the connector.
Positioning the drainage hose
• The free end must be at a height of between 80 and 100 cm. The drainage hose must be
fastened on the rear panel with the retaining clip.
• Fix the drainage hose in the correct position with the support supplied.
It is inadvisable to lengthen the hose; if necessary, contact the Service
Centre. The extension must not exceed 250 cm in length (an overlong
extension could cause the water to drain while the washing machine is
still loading). The diameter of the extension hose must be the same as
that of the original drainage hose.
Note: the free end must not be immersed in water. Connect the
drainage hose securely in order to prevent leakage.
Connection of power supply
Check the following items before connection to the power supply.
• whether the socket is able to support the washing machine's maximum load (the socket
and the power cable must be able to support a maximum current of no less than 15A).
• whether the mains voltage conforms to the required value.
• if the power socket to which the washing machine is connected is not the same as the plug,
replace it with a suitable one; alternatively, consult a specialised engineer or the Service
Centre for a suitable socket. The washing machine must be correctly earthed.
• the supplementary earth cable is not necessary if the power socket is earthed.
• the supplementary earth cable is installed at the top of the rear panel of the washing
machine and earthed if the power supply socket has no earth connection.
Note: do not connect the supplementary earth cable to the water hose or heating pipe.
Washer And Dryer
10
Model:HTD1268 SERIES
water inlet valve connector