Haier HTD1268 Service Manual page 23

Err10
Error message: The water level sensor circuit short cut or open
Troubleshooting:
Check if the wire of water levle sensor
is connected properly
N
Check if the water levle sensor
is damaged
N
Replace PCB
Err12
Failure information: drying waterlevel sensor abnormity
Check if water switch hose and air collector
are jammed
N
Pull out water switch inserts and turn on
power, then set wash mode. While water
is entering at the position of 1/4 glass
window, check the resistance between
and , is it 0? Check the resistance
between and , is it infinite?
N
Replace PCB
Err13
Failure information: The door is not properly closed after the activation of the procedure
Processing mode:Please refer to Err1
Err14
Failure information: when spined, clothes is unevenly distributed
Processing mode: Quiver and scatter the clothes to make it even. If there is still any
alarm, pleasereplace the PCB.
Quiver and scatter the clothes to make it even.
N
Replace PCB
Washer And Dryer
Y
Y
Y
Troubleshooting.
Quiver and scatter the clothes to make it even.
Y
22
Model:HTD1268 SERIES
Connect it well
Replace it
Clean water switch hose and air
collector
Replace water pressure switch
Y