Replacing The Display Assembly; Procedure; Post-Requisites - Dell Inspiron 15 5000 Service Manual

Replacing the display assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Place the palm-rest assembly at the edge of the table with the coin-cell battery
facing away from the edge.
2 Align the screw holes on the display hinges with the screw holes on the palm-
rest assembly.
3 Replace the screws that secure the display hinges to the palm-rest assembly.
4 Close the display and turn the computer over.
5 Route the display cable through the routing guides on the palm-rest assembly.
6 Slide the display cable to the connector and press down on the latch to connect
the display cable to the system board.
7 Route the antenna cable through the routing guides on the palm-rest assembly.

Post-requisites

1 Follow the procedure from step 3 to step 8 in
2 Replace the keyboard.
3 Replace the wireless
4 Replace the hard
5 Replace the base
6 Replace the optical
7 Replace the battery.
76
computer. After working inside your computer, follow
After working inside your
card.
drive.
cover.
drive.
computer. For more safety best
www.dell.com/
"Replacing the computer
Before
base".