Kenwood KDC-BT610U Instruction Manual page 14

BLUETOOTH®
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN –10 to +10 (–4): The sensitivity of the microphone increases as the number increased.
NR LEVEL –5 to +5 (0): Adjust the noise reduction level until the least noise is being heard during
a phone conversation.
ECHO CANCEL –5 to +5 (0): Adjust the echo cancellation delay time until the least echo is being heard
during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 1 to 30: The unit answers incoming call automatically in the selected time (in seconds). ;
OFF: Cancels.
BATT/SIGNAL *
(For
AUTO: Shows the strength of the battery and signal when the unit detects a Bluetooth
device and the Bluetooth device is connected. ; OFF: Cancels. Clock time is shown.
* Functionality depends on the type of the phone used.
14
ENGLISH
.
.
)
Make a call
You can make a call from the call history, phonebook, or
dialing the number. Call by voice is also possible if your
mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
to switch to another phone.
Default: XX
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3 2
Repeat step
activated or follow the instructions stated on the
selected item.
4
Press and hold
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone
Default: XX
2 Press the volume knob to call.
until the desired item is selected/
to exit.
number.
• : "INCOMING", "OUTGOING", or
"MISSED" is shown on the lower part of the display to
indicate the previous call status.
: "I" indicates call received, "O"
indicates call made, "M" indicates call missed.
• Press DISP to change the display category
(NUMBER or NAME).
• "NO DATA" appears if there is no recorded call
history.
again
.