Setting Trackball, Joystick, Search Dial, And Double-Click Sensitivity - Sony DVS-9000 System User Manual

[KEY] button operation mode for key source bus operations: For key
source bus operations, specify the operation mode of the [KEY] button
in the auxiliary bus control block in the <Key Source Bus Select
Mode> group, as follows.
Key: If you select this, the [KEY] button is always unlit, and this mode
Video & Key: The [KEY] button is enabled, and either video or key
CCP-9000/9000A-specific button settings: Press [CCP-9000 Button],
and skip to step 3.
3
If required, make the following settings.
DME channel selection mode: To set the mode when one of the [DME1]
to [DME4] buttons in the key delegation section is pressed to select the
DME channel, select either of the following in the <DME Select>
group.
Override: Forcibly select the selected channel. (Later selection takes
precedence).
Pre Select: It is not possible to select a channel that has already been
Operation mode of the [XPT HOLD] button in the key delegation
section: To set the operation mode of the [XPT HOLD] button in the
key delegation section, select either of the following in the <Xpt
Hold> group.
A/B Bus: When the [XPT HOLD] button is pressed, turning it on,
All Bus: When the [XPT HOLD] button is pressed, turning it on,
Setting Trackball, Joystick, Search Dial, and Double-
Click Sensitivity
You can set the operational sensitivity for trackball, joystick and the buttons
which recall the relevant menus when pressed twice, and the relation of the
rotation angle of search dial with the playback speed.
1
In the Panel >Operation menu, press the [Sensitivity].
The Sensitivity menu appears.
The status area shows a list of the items with their settings.
allows only key signals to be selected with the cross-point buttons.
signals can be selected.
otherwise selected. (Earlier selection takes precedence.)
cross-point hold is enabled for the A and B buses only.
cross-point hold is enabled for all buses used on the bank being
currently operated.
(A/B buses, Key 1 to Key 4 buses, Utility 1/2 buses, external
DME bus, DME Utility 1/2 buses)
Operation Settings (Operation Menu)
933