Mounting The Optional Accessories; Maintenance And Inspection - Hitachi FSV 10SA Handling Instructions Manual

MOUNTING THE OPTIONAL ACCESSORIES

1. Attaching a sponge pad (magic type) or a stick-on pad
Loosen the M4 × 10 screws (4) and remove the attached pad. Next, attach a sponge pad
(magic type) or a stick-on pad.
CAUTION
Replace the pad only. Use the other parts without removing them.
2. Attaching magic type sanding paper or stick-on type sanding paper
Match the sanding paper's hole with the pad's hole and strongly push the sanding paper
with the palm of your hand to fasten it securely in place.

MAINTENANCE AND INSPECTION

1. Empting and cleaning the Dust Bag
If the dust bag contains too much saw dust, dust collection will be aff ected. Empty the dust
bag when it gets full.
Remove the dust bag, open the fastener, and dispose of the contents.
2. Inspecting the sanding paper
Since use of worn-out sanding paper will degrade effi ciency and cause possible damage to
the pad, replace the sanding paper as soon as excessive abrasion is noted.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should
any of the screws be loose, retighten them immediately. Failure to do so could result in
serious hazard.
4. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool.
Exercise due care to ensure the winding does not become damaged and/or wet with oil or
water.
5. Replacing supply cord
If the supply cord of Tool is damaged, the Tool must be returned to Hitachi Authorized
Service Center for the cord to be replaced.
6. Servicing
Consult an authorized Service Agent in the event of power tool failure.
7. Service parts list
CAUTION
Repair, modifi cation and inspection of Hitachi Power Tools must be carried out by
a Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi Authorized
Service Center when requesting repair or other maintenance.
In the operation and maintenance of power tools, the safety regulations and
standards prescribed in each country must be observed.
17
English