KitchenAid KFGR270LSS Technical Education page 35

6. To remove a spark module:
a) Loosen (do not remove) the two spark
module screws (see the photo in step
5b on page 4-2).
b) Remove the cover from the spark mod-
ule.
c) Remove the strip of insulation.
Spark Module Cover
d) Disconnect the wires and battery con-
nector from the terminals. NOTE: The
wire connectors are different sizes to
prevent miswiring. The two larger wire
connectors are for the ignition switch,
and the smaller wire connectors are for
the ignitors. The ignitor connectors may
be connected to any of the smaller
terminals.
Battery Connector
2 Ignition Switch Wires
Insulation Strip
Ignitor Wires (4)
7. To remove the ignition switch:
a) Remove the bezel nut from the control
panel and remove the switch.
Ignition Switch
b) Disconnect the two wires from the ter-
minals.
Ignition Switch
4-3
Bezel Nut
Wires