Troubleshooting; Optional Accessories - DeWalt DCT412 Original Instructions Manual

EN GLI SH
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Cleaning
WARNING: Blow dirt and dust off with
clean, dry air at least once a week. To
minimize the risk of eye injury, always
wear proper eye protection when
performing this.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
RECOMMENDED ACCESSORIES
• DCT4101 – 17 mm diameter camera cable
• DCT4102 – 9 mm diameter camera cable
• DCT4105 – 5.8 mm diameter camera cable
• DCT4103 – 17 mm diameter, 0.9 m long cable
extension
• Hook and magnet DCT410 (available only as
spare parts)
• Hook, magnet and mirror DCT411 (available
only as spare parts)
Consult your dealer for further information on the
appropriate accessories.
46

Troubleshooting

• Make sure the 10.8 V battery is charged.
• Make sure the screen is fully charged.
• Make sure the screen is always attached to
the handle set. The picture may freeze if you
attempt to remove the screen from the handle
set while taking a photo or video.
• Make sure the battery is installed on the handle
set when in use.
• Make sure the camera cable is attached to the
handle set properly.
• Make sure the handle set is turned on as well
as the screen.
• Make sure the back of the handle set is not
covered with debris so the screen slides on
easily and no damage to the screen occurs.
• If the screen freezes or won't turn on, insert a
small object (i.e., paper clip end) into the reset
button (s) located on the back of the screen.
• If the picture is dim, roll the brightness control
switch to brighten the LED light.
Protecting the Environment
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
WALT, have
E
product available for separate collection.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
Separate collection. This product must
not be disposed of with normal
household waste.
WALT product
E
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
WALT products once they have
E