ABB ACS800 Hardware Manual page 68

68
Connect the AGPS board as follows:
• Remove the enclosure cover by undoing the fixing screws (1).
• Ground the unit via the bottom plate of the enclosure or via terminal X1:1 of the
AGPS board.
• Connect the cable delivered with the kit between terminal block X2 of the AGPS
board (2) and drive terminal block X41.
WARNING! Use only the AGPS cable delivered the the kit. Using another cable or
modifying the cable may cause a malfunction of the drive.
• Connect a cable between connector X1 of the AGPS board (3) and the
115...230 V source.
• Fasten the enclosure cover back with screws.
115...230 V
Installation of AGPS board (Prevention of Unexpected Start, +Q950)
3
1
2
X2