Connecting The Control Cables; Terminals - ABB ACS800 Hardware Manual

62

Connecting the control cables

Lead the cable through the control cable entry (1).
Connect the control cables as described below. Connect the conductors to the
appropriate detachable terminals of the RMIO board [refer to chapter
and I/O board

Terminals

Frame sizes R2 to R4
The control cable connection terminals are
exposed when the control panel mounting platform
is turned aside by pulling this knob. Be careful, do
not use excess force when pulling.
Terminal for optional
Prevention of Unexpected
Start
I/O cables: Ground the
control cable shields in the
holes with screws. See
section 360 degrees
grounding.
Electrical installation
(RMIO)]. Tighten the screws to secure the connection.
Detachable connection terminals (pull up)
X39 for control panel cable
X41
1
Motor control
Optional module 1
Optional module 2
DDCS communication
option module 3:
RDCO
Place the warning
sticker here