Installation Checklist; Checklist - ABB ACS800 Hardware Manual

Installation checklist

Checklist

Check the mechanical and electrical installation of the drive before start-up. Go
through the checklist below together with another person. Read the
instructions
Check
MECHANICAL INSTALLATION
The ambient operating conditions are allowed. (See
IEC data or NEMA
The unit is fixed properly on a vertical non-flammable wall. (See
The cooling air will flow freely.
The motor and the driven equipment are ready for start. (See
installation: Motor selection and compatibility, Technical
ELECTRICAL INSTALLATION (See
The +E202 and +E200 EMC filter capacitors are disconnected if the drive is connected to an
IT (ungrounded) system.
The capacitors are reformed if stored over one year (refer to ACS 600/800 Capacitor
Reforming Guide [64059629 (English)].
The drive is grounded properly.
The mains (input power) voltage matches the drive nominal input voltage.
The mains (input power) connections at U1, V1 and W1 and their tightening torques are OK.
Appropriate mains (input power) fuses and disconnector are installed.
The motor connections at U2, V2 and W2 and their tightening torques are OK.
The motor cable is routed away from other cables.
There are no power factor compensation capacitors in the motor cable.
The external control connections inside the drive are OK.
There are no tools, foreign objects or dust from drilling inside the drive.
Mains (input power) voltage cannot be applied to the output of the drive (with bypass
connection).
Drive, motor connection box and other covers are in place.
on the first pages of this manual before you work on the unit.
data, Ambient conditions.)
Planning the electrical installation, Electrical
Mechanical installation, Technical
Mechanical
Planning the electrical
data: Motor connection.)
79
Safety
data:
installation.)
installation.)
Installation checklist