Philips DreamStation Go User Manual page 5

1. Safety Information
Patient circuits
and tubing
Improperly
functioning
device
Power cord
2
The device should be used only with masks and connectors
recommended by Philips Respironics or with those recommended
by the health care professional or respiratory therapist. A mask
should not be used unless the device is turned on and operating
properly. The exhalation port(s) associated with the mask should
never be blocked.
Explanation of the Warning: The device is intended to be used
with special masks or connectors that have exhalation ports to
allow continuous flow of air out of the mask. When the device is
turned on and functioning properly, new air from the device flushes
the exhaled air out through the mask exhalation port. However,
when the device is not operating, enough fresh air will not be
provided through the mask, and exhaled air may be rebreathed.
If you are using a full face mask (a mask covering both your
mouth and your nose), the mask must be equipped with a safety
(entrainment) valve.
Do not pull or stretch the tubing. This could result in circuit leaks.
Inspect the tubing for damage or wear. Discard and replace the tubing
as necessary.
If you notice any unexplained changes in the performance of the
device, if it is making unusual sounds, if water is spilled into the
enclosure, or if the enclosure is cracked or broken, discontinue use
and contact your supplier.
Route the power cord to the outlet in a way that will prevent the cord
from being tripped over or interfered with by chairs or other furniture.
This device is activated when the power cord is connected.
Use only power cords supplied by Philips Respironics for this device.
Use of power cords not supplied by Philips Respironics may cause
overheating or damage to the device.
To avoid strangulation hazards, ensure that all cords connected to the
device and battery pack are properly routed.