D-Link DAP-2695 Command Line Interface Reference Manual page 13

get assoclimitstatus
get mcastrate
get wlancount
get wlan_utilization
get d-wepkeylen
get d-wepkeyupdate
Set Command:
set apmode
config wlan
set band
set ssid
set ssidhidden
set autoChannel
set channel
set cwm
set wireless
set wlmode_db
set beaconinterval
set dtim
set txpower
set wmm
set acktimeout_a
set acktimeout_g
set shortgi
set igmpsnoop
set assoclimit
set mcastrate
802.11 b/g /n Access Point Command Line Interface Manual
Display Association Limit setting status
Display mcast rate
Display wlan count
Get Wlan utilization
Display 802.1X dynamic WEP Key Length
Display 802.1X dynamic WEP Rekey Interval(in Secs)
Function
Set AP Operate Mode
Set AP Band (0:2.4G/1:5G)
Set ap band (2.4G or 5G)
Set Service Set ID
Set ssidhidden
Set AutoChannel
Set Channel (1--11)
Set CWM
Set Wireless
Set Wlmode
Set Beaconinterval (range:25--500)
Set DTIM (1--15)
Set Txpower
Set WMM
Set acktimeput in A band (range:25--200)
Set acktimeput in G band (range:48--200)
Set Shortgi
Set igmp snooping states
Set Association Limit
Set mcast rate
get assoclimitstatus
get mcastrate
get wlancount
get wlan_utilization
get d-wepkeylen
get d-wepkeyupdate
set apmode [ap/apc/wdsap/wds]
config wlan [0/1]
set band [2.4g/5g]
set ssid
set ssidhidden
set autoChannel
set channel
set cwm
set wireless
set wlmode_db
set beaconinterval [25-500]
set dtim [1-15]
set txpower
set wmm
set acktimeout_a
set acktimeout_g [48-200]
set shortgi
set igmpsnoop [enable/disable]
set assoclimit [enable/disable/number]
set mcastrate
13
Syntax