Processor/Dimm Blank; Removing A Processor/Dimm Blank - Dell PowerEdge M420 Owner's Manual

c) LOM riser card
2. Slide the new blade system board into the open end of the blade chassis until the blade release latch engages.
NOTE: Ensure that the system board is parallel with the chassis.
3. Replace the mezzanine card.
4. Reinstall the SSD backplane.
5. Replace the SSD(s).
If there are two drives, be sure to reinstall them in their original locations.
6. Install the SD card(s).
7. Install the blade in the sleeve.
8. Import your new or existing iDRAC Enterprise license. For more information, see the
support.dell.com/manuals.

Processor/DIMM Blank

CAUTION: If you are permanently removing a processor, you must install a socket protective cap and a processor /
DIMM blank in the vacant socket to ensure proper system cooling. The processor/DIMM blank covers the vacant
sockets for the DIMMs and the processor.

Removing A Processor/DIMM Blank

1. Remove the blade from the sleeve.
2. Remove the blade system board. For more information, see Removing The Blade System Board.
3. Lift the processor/DIMM blank away from the system.
42
Downloaded from www.Manualslib.com manuals search engine
iDRAC7 User's Guide at