Receiving - Kenwood NX-200 Instruction Manual

■ Making Individual Calls (Digital)
(NX-200/ NX-300/ NX-200G/ NX-300G Only)
If a key has been programmed with Individual or
Individual + Status, you can make calls to specifi c
persons.
1 Press the key programmed as Individual or
Individual + Status.
2 Press
• On keypad models, you can enter a unit ID directly.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.

RECEIVING

Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "S
page 26 for details.
■ Receiving Group Calls (Digital)
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller's voice.
When you receive a group call on a Trunking channel, the
transceiver automatically switches to the communications
channel to receive the call.
■ Receiving Individual Calls (Digital)
When you receive an individual call, a ringing tone will sound
and the caller's ID will appear on the display (NX-200/ NX-200G
/NX-300/ NX-300G Only). To respond to the call, press and
hold the PTT switch and speak into the transceiver as you
would during a normal transmission.
14
/ to select a unit ID from the list.
" on
IGNALING