Table of Contents
Advertisement
3DQDVRQLF
2
1.2.3 I
C bus
The microcontroller contains an I
communication system, it requires data line ( SDA ) and associated serial clock line (SCL) ( Philips is
the patent holder of the I
2
output pins. The I
C bus is used by the microcontroller to control the video processor and the non-
volatile memory
Microcontroller
2
Œ
1
C Bus protocol (SCL and SDA lines)
START condition : START is identified by a high to low transition of the SDA line while the clock SCL
is stable in the high state. A START condition must precede any command for data transfer.
STOP condition : STOP is identified by a low to high transition of the SDA line while the clock SCL Is
stable in the high state. A STOP condition terminates communication.
Acknowledge Bit (ACK) : An acknowledge signal is used to indicate a successful data transfer. The
bus transmitter, either master or slave, will release the SDA bus after sending 8 bits of data. During tile
9th clock pulse period the receiver pulls the SDA bus low to acknowledge the receipt of the 8 bits of
data.
SCL
SDA
SCL
SDA
*
2
C bus transceiver hardware interface. The I
2
C bus standard). Both the SCL and SDA pins are input and open collector
5 V
SDA
SCL
( Master )
Fig : 14 : I
Start
SDA
condition
input
1
2
MSB
Fig. 15 : I
EEPROM
( Slave )
2
C bus devices
SDA
change
3
8
2
C protocol
22
2
C bus is a serial
TDA8374
( Slave )
Stop
condition
9
ACK
Advertisement
Table of Contents
