Motorola VERVE CAM User Manual page 36

responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Increase
the separation between the equipment and receiver. •
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. •
Consult the dealer or an experienced radio/TV
technician for help.
Specific Absorption Rate (SAR) Information
This device meets the government's requirements for
exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for
exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless devices employs a
unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC / by the RSS-
102 is 1.6 W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC
with the device transmitting at its highest certified
power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level,
the actual SAR level of the device while operating can
be well below the maximum value. This is because the
device is designed to operate at multiple power levels
so as to use only the poser required to reach the
en
Help & more 35