Warnings; Cautions - Epson DM-D210 Technical Reference Manual

Warnings

 To avoid risk of electric shock, do not set up this product or handle cables during a thun-
 Never insert or disconnect the power plug with wet hands.
WARNING
 Handle the power cable with care.
 Be sure to use the specified power source.
 Do not place multiple loads on the power outlet.
 Shut down your equipment immediately if it produces smoke, a strange odor, or unusual
 Never attempt to repair this product yourself.
 Never disassemble or modify this product.
 Do not allow foreign matter to fall into the equipment.
 If water or other liquid spills into this equipment, do not continue to use it.
 Do not use aerosol sprayers containing flammable gas inside or around this product.
 Do not connect cables in ways other than those mentioned in this manual.
 Do not use this product in locations subject to high humidity or dust levels.

Cautions

 Be sure to set this equipment on a firm, stable, horizontal surface.
 Do not place heavy objects on top of this product. Never stand or lean on this product.
CAUTION
 To ensure safety, unplug this product before leaving it unused for an extended period.
 Do not drop the this product because you may damage the built-in vacuum fluorescent
 Using in the presence of silicon gas (silicon adhesive, silicon oil, silicon powder, etc.)
4
derstorm.
Doing so may result in severe shock.
Improper handling may lead to fire or electric shock.
 Do not modify or attempt to repair the cable.
 Do not place any heavy object on top of the cable.
 Avoid excessive bending, twisting, and pulling.
 Do not place the cable near heating equipment.
 Check that the plug is clean before plugging it in.
 Be sure to push the plug all the way in.
Connection to an improper power source may cause fire or shock.
Overloading the outlet may lead to fire or shock.
noise.
Continued use may lead to fire. Immediately unplug the equipment and contact your dealer
or a Seiko Epson service center for advice.
Improper repair work can be dangerous.
Tampering with this product may result in injury or fire.
Penetration by foreign objects may lead to fire.
Continued use may lead to fire. Unplug the power cord immediately and contact your dealer
or a Seiko Epson service center for advice.
Doing so may cause fire.
Different connections may cause equipment damage or fire.
Excessive humidity and dust may cause equipment damage or fire.
The product may break or cause injury if it falls.
Equipment may fall or collapse, causing breakage and possible injury.
display.
including siloxane and of malignant gas (nitric acid, hydrosulfuric, ammonia, chlorine,
etc.) may cause contact failure at contact points in a mechanical switch, etc., in a short
time because of adhesion or oxidization of the insulation film.