DP-110/DP-210 Connector Specifications
This section explains the DP-110/DP-210 connector specifications.
Computer Interface Connector (Serial)
Type: D-Sub 25-pin connector
Pin assignments
Pin
Signal
Number
Name
1
FG
2
TXD
3
RXD
*1
4
RTS
*2
6
DSR
7
GND
88
14
1
Signal
Direction
-
Frame ground
Stand-alone connection:
Output
Transmits data to the computer from the this product
Pass-through/Y-type connection:
Transmits data to the computer from the TM printer.
Input
Receives data from the computer.
(Computer -> This product)
Output
This indicates whether the display is ready to receive data.
[SPACE]: The display can receive data.
DTR goes to SPACE under the following conditions:
When the display first becomes ready to receive data after power on.
When the self-test has ended.
When the remaining space in the receive buffer becomes 50 bytes or
more after having been 40 bytes or less.
[MARK]: The display cannot receive data.
DTR goes to MARK under the following conditions:
The period from when power is turned on to when the display first
becomes ready to receive data.
When the self-test is executed.
When the remaining space in the receive buffer becomes 128 bytes or
less (buffer-full state).
When DSR MARK is on, if the TM printer is selected by a peripheral device
command.
Input
Indicates whether the computer is ready to receive data.
[SPACE]: The computer is ready to receive data.
[MARK]: The computer is not ready to receive data.
-
Signal GND
25
13
Function
*2