Install Sim Card; Equipment Required; Installation Procedure - Honeywell Thor VM2 User Manual

Install SIM Card

A SIM card may be required for WWAN.
Note: The SIM card is not hot-swappable. After installing or removing a SIM card, the Thor VM2 must be rebooted for the change
to take effect.

Equipment Required

The following equipment is user-supplied:
• SIM card for desired carrier
• Torquing tool capable of measuring inch pounds
• #2 Phillips screwdriver bit

Installation Procedure

1. For convenience, the Thor VM2 can be removed
from the dock, though it is not necessary.
2. If the Thor VM2 remains in the dock, disconnect the
power cable from the dock.
3. Place the Thor VM2 in Suspend by pressing the
Power button.
4. Place the Thor VM2 face down on a stable surface.
5. Using a #2 Phillips bit loosen the M3 screws and
then remove the tethered access panel with the
SIM label. This panel is on the right hand side when
the Thor VM2 is face down with the top away from
the user.
4 - 51