Stylus; Double-Tap; Calibration - Honeywell Thor VM2 User Manual

Stylus

Start > Settings > Control Panel > Stylus
Use this control panel option to set stylus double-tap sensitivity properties and calibrate the Thor VM2 touch panel when
needed.

Double-Tap

Follow the instructions on the screen and tap the OK button to save any double-tap changes.

Calibration

Calibration involves tapping the center of a target. If you miss the center, keep the stylus on the screen, slide it over the
target's center, and then lift the stylus.
To begin, tap the Recalibrate button on the screen with the stylus. Press and hold the stylus on the center of the target
as it moves around the screen. Press the Enter key to keep the new calibration setting or press the Esc key to revert to
the previous calibration settings.
Note: If the touch screen looses calibration on a Thor VM2, you must use a USB mouse or keyboard attached to the
Thor VM2 to access this tab to recalibrate the touch screen unless a
assigned to launch the calibration utility.
5 - 96
Programmable Key (page 5-86) has been