1. Make sure that the Disk Array Controller (S-ATA) is installed in the system. If not,
install the Disk Array Controller into the system.
on installing the Disk Array Controller.
2. Connect the LED cable connector (black) to the LED connector pins (2) of the HDD
Cage.
LED cable
RED cable
- The LED Cable is an accessory of the system.
- Refer to the system user's guide for details about connecting the LED
cable to the motherboard.
Making Connections 3-2
Note:
Refer to the Disk Array Controller user's guide for details
Figure 3-1: Connecting the LED Cable
Note:
BLACK cable