3. Connect the power cables to the two power connectors on the HDD Cage.
for the power cable connection to the HDD Cage.
Power cables
HDD cage
4. Route the S-ATA cables within the chassis of the system as shown in the figure below.
- The S-ATA cables are accessories of the Disk Array Controller.
- Make sure that the connectors at the other ends of the S-ATA cables
are connected to the Disk Array Controller. If not, connect the S-ATA
connectors to the Disk Array Controller. Refer to the Disk Array
Controller user's guide for more details.
LED cable
Note:
Use two power cables instead of a single power cable
Figure 3-2: Connecting the Power Cables
Note:
Figure 3-3: Routing the S-ATA Cables
S-ATA cables (4)
Making Connections 3-3