Preparation; Supplied Accessories; Installing The Antenna; Installing The Battery Pack - Kenwood TH-D74E User Manual

PREPARATION

SUPPLIED ACCESSORIES

After carefully unpacking the transceiver, identify the items
listed in the table below. We recommend you keep the box
and packaging for shipping.
Item Comments
Antenna
KNB-75L:
Li-ion battery pack
1800 mAh
Part Number:
Charger
W0H-0033-XX
(AC Voltages:
Part Number:
100 - 240 V, 50/60 Hz)
W0H-0034-XX
for the charger
AC power cable
W0H-0034-XX
Belt clip
Warranty card
English/ French/
Spanish
User Guide
Italian/ German/
Dutch

INSTALLING THE ANTENNA

Hold the supplied antenna by its base, then screw it into the
connector on the top panel of the transceiver until secure.

INSTALLING THE BATTERY PACK

Note:
◆ Because the battery pack is provided uncharged, you must
charge the battery pack before using it with the transceiver.
Match the guides of the battery pack with the corresponding
grooves on the upper rear of the transceiver, then fi rmly press
the battery case to lock it in place.
6
To remove the battery pack, lift the release lever to unlock the
battery pack. Lift the battery pack away from the transceiver.
Quantity
TH-D74
A E
1 1
1 1
1 –

CHARGING THE BATTERY PACK

– 1
The battery pack can be charged after it has been installed
– 2
onto the transceiver. (The battery pack is provided uncharged
for safety purposes.)
1 1
1 Confi rm that the transceiver power is OFF.
• While charging the battery pack, leave the transceiver
1 1
power OFF.
2 Insert the charger plug into the DC-IN jack of the
1 1
transceiver.
– 1
DC IN jack
3 Plug the charger into an AC wall outlet.
• Charging starts and "Charging" appears on the display.
• "Charging" disappears when charging is completed.
• The backlight is ON when pressing any key while
charging.
• "Charging" does not appear when charging with the
optional KSC-25LS.
4 It takes approximately 3.5 hours to charge an empty
KNB-75L Li-ion battery pack. After 3.5 hours, remove the
charger plug from the transceiver DC-IN jack.
5 Unplug the charger from the AC wall outlet.
Note:
◆ Never leave the battery pack in direct sunlight.
◆ The transceiver becomes warm while charging the battery pack.
◆ While the battery pack is charged, the ambient temperature
must be within 0°C ~ 40°C (32°F ~ 104°F). Otherwise, charging
does not start. If the transceiver senses that the temperature is
more than 60°C (140° F) during charging, the transceiver stops
charging.
◆ Before recharging the battery pack, use the battery pack until the
transceiver stops receiving.
◆ Do not plug the charger into the DC-IN jack for more than 24 hours.
◆ Do not expose the charger to dripping or splashing conditions.
No objects fi lled with liquids, such as vases, shall be placed on
the AC adapter or charger.
◆ Do not place the charger into the liquids.
◆ Unplug the charger as soon as possible after the charging period
is over.
◆ The charger plug for an AC wall outlet should be used to
disconnect an AC adapter from an AC outlet, and the charger plug
must remain readily operable.
TH-D74A
TH-D74E