Dtc Digital Pcb, Version 2 - ABB PGC5000 Series Service Instructions Manual

PGC5000
PGC5000 Series Service Instructions

5.3.4 DTC digital pcb, version 2

This DTC digital PCB has eight LEDs (CR1 to CR8) on the upper left-hand edge for basic troubleshooting. CR1 through CR6 are
Green; CR7 and CR8 are Red. Their display condition (On, Off, Solid or Blinking) indicates the board state.
CR1: Green, Blinking
CR2: Green
CR3: Blinking
CR4: Blinking
CR5: Blinking
CR6: Blinking
OFF
CR7: Blinking
Blinking (unison CR1)
CR8: OFF
If the Digital Signal Processor (DSP) system fails during power-up, the LED bank indicates what was being attempted. No green
LEDs (CR1 to CR6) are blinking and CR7 and CR8 are off. CR1 (MSB) through CR6 form a binary code as follows:
000001 CAN initialization error
000010 application initialization error
000011 CAN node/network setup error
000100 no other node on CANBus, still trying
000101 CAN and application timer engaged
000110 reload in progress
000111 CAN disabled, reload jumping to start over
001000 bootloader initialization
001001 bootloader CAN setup
001010 bootloader start hardware setup
001011 bootloader end hardware setup
001100 bootloader received reset application
100001 bootloader flash erase in progress
110011 bootloader flash program in progress
111111 bootloader flash program complete
001110 start board setup
001111 start DSP initialization
010000 end DSP initialization
010001 Analog/Digital initialization
010010 temperature zone setup
010011 temperature conversion setup
010100 number valves detection
010101 end board setup
010111 start DTC initialization
011000 valve initialization
011001 safety switch initialization
011010 PIC initialization
011011 signal testing initialization
011100 purge testing initialization
011101 miscellaneous initialization
011110 end DTC initialization
100000 start setup CANopen
100001 CAN PDO setup
100010 end setup CANopen
100100 solenoid start initialization
100101 solenoid access
100110 solenoid test
100111 solenoid reverse test
101000 solenoid test complete
101001 solenoid end initialization
101111 received reset application
SI/PGC5000-EN, Rev B
Blinks when the downloaded code is running.
Indicates method execution in progress.
RTC signal is detected.
AC Power present.
PIC communication present..
During Initial Power on
Application code running.
T-Rating Error
No power to DTC board
Normal Operation
5 Diagnostics and troubleshooting
19