Replacement Parts; Ordering Information; Equipment Identification; Master Controller Config Identification - ABB PGC5000 Series Service Instructions Manual

PGC5000
PGC5000 Series Service Instructions

8 Replacement parts

8.1 Ordering information

Since the particular application defines the component parts specific to any given system, please refer to
the "Recommended Spare Parts Lists" in the analyzer's Data Package to obtain the full and correct part
number for the desired part or assembly.

8.1.1 Equipment identification

Include the following information, found in the Data Package and on the analyzer nameplate, in any communication concerning
replacement parts or components:
• ABB Sales Order Number.
• Analyzer Model Number.
• Analyzer Part Number (P/N) and serial number.
For serial numbered subassemblies such as PCBs, include the serial number and the part number (including dash
•
number and revision letter) for the subassembly in the request. If a PCB requires conformal coating, prefix the PCB
part number with the letters "CC."
• Applicable references from the "Recommended Spare Parts List" of the Data Package, included with each analyzer.
• Description of part.
8.1.2 Master controller configuration identification
The Master Controller nameplate (see Figure 8.1) lists the Master Controller configuration information.
Model
Number
Fig. 8.1. Typical Master Controller Nameplate
The hardware configuration consists of the model number and sales order number.
SI/PGC5000-EN, Rev B
Sales Order
Number
8 Replacement parts
75