ABB PGC5000 Series Service Instructions Manual page 25

PGC5000
PGC5000 Series Service Instructions
INDICATOR ISSUE
Low-Low Concentration is below
Concentration Low-Low Setpoint
Low Concentration is below
Concentration Low Setpoint but above
Low-Low Setpoint
High Concentration exceeds the
Concentration High Setpoint but below
High-High Setpoint
High-High Concentration exceeds the
Concentration High-High Setpoint
RF Low Limit Calculated response factor
out of range (low) (% of
deviation from previous RF)
RF High Limit Calculated response factor
out of range (high) % of
deviation from previous RF)
Retention Time Retention time is below
Low Low Setpoint
Retention Time Retention time exceeds
High High Setjpoint
Validation Measurement out of range
(% of deviation from known
standard)
Missing No peak found matching a
Component component defined in the
analysis
Unknown Peak detected in the
Component analysis and not defined in
the method
Sample Flow Lost Future functionality:
Sample flow is lost
Digin Check TCF Programmable Input
checks
Psrs Check TCF Pressure Check failed
Invalid Analysis Analysis failed validation
Analysis Aborted 1. Analysis does not
complete analysis due to
temperature, pressure
and/or digital input
programmed command.
2. User intervention using
Stop Now command.
3. Related oven issues.
Offline Schedule Offline: Oven is
powered down
Idle Schedule Stopped or
paused
SI/PGC5000-EN, Rev B
RESOLUTION (CHECK & CORRECT)
Information Only. Adjust Limits under
the Setup tab as needed.
Information Only. Adjust Limits under
the Setup tab as needed.
Information Only. Adjust Limits under
the Setup tab as needed
Information Only. Adjust Limits under
the Setup tab as needed
Information Only. Adjust Limits under
the Setup tab as needed.
Information Only. Adjust Limits under
the Setup tab as needed
Information Only. Adjust Limits under
the Setup tab as needed.
Information Only. Adjust Limits under
the Setup tab as needed. Possible
leak. Possible defective EPC pressure
sensor. Possible plugged inlet filter.
Information Only. Adjust Limits under
the Setup tab as needed. Flows
incorrectly set. Defective EPC sensor.
Information. Edit analysis as needed.
Check flows. Verify correct operation
operation of all analytical valves.
Verify sample flow to oven.
Restore Sample flow. Replace sample
flow switch as necessary
See Digital inut TCF in Operating
Instructions.
See pressure check TCF in
Operating Instructions.
1. From Analysis tab edit Analysis to
meet requireemnts.
2. User controlled.
1. Check Pressure, Temperature
and/or Digital Inputs. Correct problem
accordingly.
2. User controlled.
3. Check oven related indicators for
more information.
Information Only. Resets when oven
power is restored.
Information Only.
5 Diagnostics and troubleshooting
RESET SOURCE
When Component
reported.
When Component
Reported
When Component
reported
When Component
reported
When Component
recalibrated
When Component
recalibrated
When Component
Reported
When Component
reported
Wen Component
revalidated
When Analysis
reported
When Analysis
Reported
AOC Analysis
AOC Analysis
AOC Analysis
AOC Analysis
AOC Analysis
AOC Schedule
AOC Schedule
25