For Wireless Network Users - Brother ADS-2600W Quick Setup Manual

For Wireless Network Users

For wireless network interface users
8
Before you begin
Although your Brother machine can be used in both a wired and wireless network, only one of the connection
methods can be used at a time.
Note
If you have previously configured the wireless settings of the machine you must reset the network settings
before you can configure the wireless settings again.
On your machine, press
Swipe up or down, or press a or b to display Network Reset, and then press Network Reset.
Press Yes to accept. Hold down Yes for 2 seconds to confirm.
Note
To set up your machine in Ad-hoc mode (connected to a wireless capable computer without an access
point/router) you can find instructions in the Network User's Guide on the DVD-ROM.
You can view the Network User's Guide by following the instructions below.
1 Turn on your computer. Insert the DVD-ROM into your DVD-ROM drive.
®
For Windows :
2 Choose your model and the language. The DVD-ROM top menu will appear.
3 Click User's Guides, and then click HTML documents. The top page will appear.
4 Click Network User's Guide.
For Macintosh:
2 Double-click User's Guides. Choose your model and the language.
3 Click User's Guides.
9
Choose your wireless setup method
The following instructions will offer three methods for setting up your Brother machine on a wireless network.
Choose the method you prefer for your environment.
a
Setup using the installation DVD-ROM and a USB cable (Windows
You need to temporarily use a USB cable during configuration.
It is recommended that you use a computer wirelessly connected to your network for this method.
If you are using Windows
point/router by network cable, you need to know your wireless settings. Please write down your
wireless network settings in the area on page 12.
Now go to
and Network.
®
XP, or currently using a computer connected to an access
®
& Macintosh)
page 13
11