3.9.2
Reydisp Software
When the relay is latched, LEDs can be reset by sending an appropriate command over the data communications
channels using Reydisp software.
In the Reydisp Evolution screen, navigate to Relay > Control and click Reset Flags.
3.9.3
TEST/RESET► Key
From the Relay Identifier Screen, reset the LEDs and outputs by pressing the TEST/RESET► key.
© 2017 Siemens Protection Devices Limited
Figure 3-10 Reset LEDs Outputs: Reydisp Software Input Matrix
Figure 3-11
7SR45 Description of Operation
Reset Flags
Chapter 1 Page 25 of 34