Data Mode Display - Philips ProScreen PXG10 User Manual

8. OPERATION

DATA MODE DISPLAY

Data display Fine Sync adjustments
When displaying computer patterns which are very detailed
(tiling, vertical stripes, etc.), interference may occur between
the LCD pixels, causing flickering, vertical stripes, or contrast
irregularities in portions of the screen. Should this occur, adjust
"Clock" , "Phase" , "H-Pos" and "V-Pos" for optimum computer
image (Fine Sync adjustment).
1. Select the desired computer input mode by pressing either
Data 1 or Data 2 at the projector local keyboard or toggling
the Input button on the Remote Control unit.
2. Press Menu. Menu bar and "Picture" menu screen appear.
GUI operation guide is also displayed.
3. Press 1 / 2 to select "Fine Sync" .
4. Press 3 / 4 to select a specific adjustment item.
5. Press 1 / 2 to move the "I" mark of the selected
adjustment item to the desired setting.
6. To exit from the GUI, press Menu.
To reset all adjustment items, select "Reset" on the "Fine
Sync" menu screen and press OK.
Auto Sync Adjustment
– Used to automatically adjust a computer image.
– Auto Sync adjustment can be made manually by pressing
Auto sync (either on local keyboard and remote control), or
automatically by setting "Auto Sync" to "ON" in the
projector's GUI menu.
When "Auto Sync" is set to "ON":
– The sync adjustment is automatically made each time the
projector is turned on while connected to a computer or the
input selection is changed.
– The Auto Sync adjustment setting previously made is
cleared when the projector's setting is changed.
Note:
1. Press Menu.
2. Press 1 / 2 to select "Fine Sync" .
3. Press 3 / 4 to select "Auto Sync" .
4. Press 1 / 2 to select "ON" .
5 . To exit from the GUI, press Menu.
• Automatic adjustments can be made by pressing Auto sync.
• When the optimum image cannot be achieved with Auto
Sync adjustment, use manual adjustments. (See "Data
display Fine Sync adjustment").
During Auto Sync adjustment, the On-Screen Display changes:
Auto Sync adjustment may take some time to complete,
depending on the image of the computer connected to the
projector.
Auto Sync Display Function
Normally, an image is not superimposed during Auto Sync
adjustment. You can, however, choose to superimpose a
background image during Auto Sync adjustment.
1. Press Menu.
2. Press 1 / 2 to select "Options"
3. Press 3 / 4 to select "Auto Sync Disp" .
4. Press 1 / 2 to select "
image or " " to remove the background image during
Auto Sync adjustment.
5. To exit from the GUI, press Menu.
Picture control
Note:
" to superimpose a background
17