Troubleshooting - Philips SV1 User Manual

Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Philips Multimedia Projector

7.Troubleshooting

If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to correct a problem by following these hints, consult your dealer or service
center.
Under no circumstances should you try to repair the projector yourself as this could void your
warranty.
– Possible cause
• Solution
General
– Mains lead is not correctly connected.
• Check the mains lead connection.
– Lamp holder cover is not closed correctly or the lamp holder is damaged.
• Check cover for proper closure (see 'Lamp replacement' under 'Maintenance').
– Signal cable not correctly connected.
• Check signal cable connection.
– The projector is in Off position.
• Press the Standby button to turn the projector on.
In Video series mode
– Keystoning is applied on a high resolution component signal.
• Decrease keystoning until the image is correctly displayed.
For this use the 'Keystone' option in the 'Setup' menu.
In Data mode
-- Partial, scrolling or incorrectly displayed image.
• Use the 'Auto Sync' option in the 'Picture' menu.
– Input resolution is too high (and keystoning is applied).
• If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed.
For this, refer to the User Guide or support information of the computer.
• If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use 'Keystone correction' option in the 'Settings' menu.
– Input resolution is too high (and no keystoning is applied).
• Decrease the input resolution until the image is correctly displayed.
For this, refer to the User Guide or support information of the computer.
34
English User guide bCool SV1
>