Philips SV1 User Manual page 35

Poor color
Image is blurred
Picture rolls
The projector does not
react to commands from
the remote control
Indicators
Philips Multimedia Projector
7.Troubleshooting
• Adjust 'Brightness', 'Contrast or 'Colour tracking' (see 'Picture adjustment' under 'Operation' -
'On Screen Display Menu').
• Reset all projector settings in the 'Setup' menu ('Factory settings').
– Image is not focused.
• Adjust focus ring.
– Distance between projector and screen is not correct.
• Adjust the distance between the projector and the screen.
– Signal cable is not correctly connected.
• Check signal cable connection.
– Signal cable is not correctly connected.
• Check signal cable connection.
– Distance is too great.
• Reduce distance.
– Batteries are exhausted.
• Replace batteries (see 'Inserting the batteries in the remote control').
– IR sensor is obstructed.
• Remove obstacle.
Lamp indicator
– Red blinking (0.5sec. On, 0.5sec. Off): lamp start has failed.
• Disconnect projector from the mains. Reconnect and restart. If this does not solve the
problem, replace the lamp. See 'Maintenance. '
– Red blinking (1sec. On, 1sec. Off): the fans are locked.
• The projector will automatically shut down. If this problem continues, contact your Service
Center.
Temp. (temperature) indicator
– Lights up red: temperature error.
• Disconnect projector from the mains. Reconnect and restart.
If this does not solve the problem, contact your Service Center.
Standby indicator (text on Standby button/ring around Standby button)
– Lights up green: Power on mode.
– Green blinking: warming up in Power on mode.
– Lights up red: Standby mode.
– Red blinking: cooling down in Power off mode.
35
English User guide bCool SV1
>