Pattern Qualify Option; State Qualify Option - HP 54501A Operation Reference

pattern Qualify Option

state Qualify Option

When the pattern trigger option
you to define the qualifier pattern. Defining a pattern
Pattern Trigger mode.
•
Highlight the bit to be changed by pressing the selection key.
•
Change the bit by rotating the knob.
After you have pressed the selection through all four bits the active field
changed to the condition field. This field allows you to set conditions
the Pattern Trigger mode:
•
when entered
•
when exlted
>
•
when present
• <
when present
•
range
These settings activate the next field,
specific time parameters.
If the state trigger option
to define the state conditions.
As
in the State Trigger mode, you select the channel to define the state
clock. This selection is
slope is depicted with the arrowhead pointing up or down. Use the
selection key to move the highlighted bit to change the pattern. When the
has
pattern been set the is/not present setting
the highlight to the is/not present field label and pressing the selection key
again. When the label
is/not present using the knob.
is
selected, the next selection key allows
as
appropriate, so you
is
selected the next two seleetion keys allow you
reflected in the pattern with an arrow and the
is highlighted you can
as
the same
is
can set the
can be
changed by moving
ggl
t o e the setting between
Trigger Menu
in the
is
as
in
6-21