Simulating machining
5.5 Different views of a workpiece
Displaying and moving cutting planes
You can display and move cutting planes X, Y, and Z.
See also
Defining cutting planes (Page 192)
5.5.3
Side views
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
184
1.
Starting the simulation.
2.
Press the "Other views" softkey.
3.
Press the "From front" softkey if you wish to view the workpiece from
the front.
- OR -
Press the "From rear" softkey if you wish to view the workpiece from
the rear.
- OR -
Press the "From left" softkey if you wish to view the workpiece from
the left.
- OR -
Press the "From right" softkey if you wish to view the workpiece from
the right.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling