Siemens SINUMERIK 840D Operating Manual page 402

Programming technological functions (cycles)
8.5 Contour turning - only for G code programs
Parameters Description
D Maximum depth infeed - (only for ∇)
XDA 1. Grooving limit tool (abs) – (only for face machining direction)
XDB 2. Grooving limit tool (abs) – (only for face machining direction)
UX or U Finishing allowance in X or finishing allowance in X and Z – (only for ∇)
UZ Finishing allowance in Z – (only for UX)
DI For zero: Continuous cut - (only for ∇)
BL Description of unmachined part



XD - (only for unmachined part description, cylinder and allowance)


ZD - (only for unmachined part description, cylinder and allowance)


Allowance Allowance for pre-finishing - (only for ∇∇∇)


U1 Compensation allowance in X and Z direction (inc) – (only for allowance)


Set machining area Set machining area limits
limits


N Number of grooves
DP Distance between grooves
402
Cylinder
Allowance
Contour
For unmachined part description, cylinder
– Allowance or cylinder dimension ∅ (abs)
– Allowance or cylinder dimension (inc)
For unmachined part description, allowance
– Allowance on the contour ∅ (abs)
– Allowance on the contour (inc)
For unmachined part description, cylinder
Allowance or cylinder dimension (abs or inc)
For unmachined part description, allowance
Allowance on the contour (abs or inc)
Yes
U1 contour allowance
No
Positive value: Compensation allowance is kept
Negative value: Compensation allowance is removed in addition to finishing
allowance
Yes
– XA: 1. Limit XA ∅
– XB: 2. Limit XB ∅ (abs) or 2nd limit referred to XB (inc)
– ZA: 1. Limit ZA
– ZB: 2. Limit ZB (abs) or 2nd limit referred to ZB
No
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
Milling